Skip to content
NEXERA

Resources

AV power budgeting: sizing amplifiers and PoE switches

Two budgets decide whether a system works on the day: amplifier power against the speaker load, and PoE power against what the switch can deliver. For both, add up what the devices need and then leave headroom. A common working margin is to load equipment to no more than 80% of its rating.

Sizing a 70V or 100V amplifier

  1. Add up the tap settings of every speaker on the channel.
  2. Multiply by 1.25 so the load sits at 80% of the amplifier’s rating.
  3. Pick the next standard amplifier size above that figure, at the line voltage you are running.

Example: 24 ceiling speakers tapped at 6 W on a 100V line is 144 W. 144 × 1.25 = 180 W, so a 240 W channel is the right choice and a 150 W channel is not. The margin covers cable and transformer losses, peaks in the programme material and a few speakers added later.

Low-impedance loads: watch the ohms, not just the watts

Speakers wired in parallel lower the impedance the amplifier sees. For identical speakers:

Ztotal = Zspeaker ÷ n

Two 8-ohm speakers in parallel are 4 ohms; four are 2 ohms. Check two things: that the result is not below the amplifier’s minimum rated impedance, and that you compare speaker and amplifier power at that impedance. An amplifier’s output at 4 ohms is usually higher than at 8 ohms, and its datasheet gives both. A speaker’s impedance can dip to 80% of its nominal rating (IEC 60268-5), so keep a margin above the amplifier’s minimum.

Budgeting PoE across a switch

Every PoE device negotiates a power class. Budget against what the switch reserves for that class at the port, not the device’s typical draw: many switches reserve the full class allocation.

StandardTypePower at the switch portPower at the device
IEEE 802.3afType 115.4 W12.95 W
IEEE 802.3atType 230 W25.5 W
IEEE 802.3btType 360 W51 W
IEEE 802.3btType 490 W71.3 W

Example: six PTZ cameras on 802.3bt Type 3 (60 W each) and ten touch panels on 802.3af (15.4 W each) need 360 + 154 = 514 W. A switch with a 370 W PoE budget will refuse to power some of them. With the 80% margin you want at least 643 W: a switch with a 740 W budget, or the load split across two switches. Check per-port limits as well as the total.

Don’t forget the mains

Amplifiers and PoE switches both draw from the building’s circuits. Amplifier datasheets usually list current draw at idle, 1/8 power and 1/3 power. Use 1/8 for normal music and speech, 1/3 for heavily compressed background music or paging, and full power for evacuation tones or battery and UPS sizing. Then add up each rack against its circuit breaker.

Keep every budget live as the design changes

Nexera works out amplifier power matching and network switch PoE budgets in real time as you design, so adding a speaker or a camera immediately shows whether the amplifier or switch still has headroom. The Amp Advanced module adds one-click amplifier recommendations with full power, impedance and 100V validation, and a project-wide Amp Doctor audit.